eblade solonoid leaking

[jack]

ok, i had a leak from the solonoid housing of my brothers eblade, i fixed that but now it is leaking quite badly everytime we gas it up from underneath the solonoid housing where the solonoid gasket meets the housing, on a closer inspection, the gasket (black rubber bit) looks fine so what could the problem be?

jack

 

[Skeet]

In the manual i think it says something about greasing the gasket, but I cant be arsed to check right now..if not, get a new gasket and plop that in, make sure the screws are tight and that the gasket is fitted correctly.

 

[joe bob]

just like any other thing that breaks, if you dont know how to do it take it to the shop

 

[benjoshtara]

leaks

Have you got an adjustablr LPR on the front of your gun? if you have there is a possibility that you or someone has turned the pressure up to above about 100psi this will cause the soloniod to leak from the underside. Turn it right down and reset the cocking pressure.

 

[Skeet]

Didnt think of that ...yep...turn it down till it wont cock, then wind it up till it cocks everytime, then just a fraction more, for safety.

 

[jack]

got a non adjustable sledgehammer, not been touched i dont think.

 

[iplaymindgames]

its hard to tell if the gasket is leaking.. sometimes the gasket can have a small crack that u cant see and that can cause the leak.. it happened to me in the past and worr replaced it for me free

if its not that.. maybe your solenoid is damaged. its really good to buy a full cover.. i know that www.moodypaintball.com sells them

 

[dr.strangelove]

Before I went sending my marker out for repair, I'd grease the gasket and make sure it's tightly sealed to the solenoid (screws need to be tightened very well).