I have just put an eblade on my 04' prostock and im only averaging about 11 balls a second, can any one help?
Do i need to upgrade parts or change the settings?
Please help
Do i need to upgrade parts or change the settings?
Please help
Eblade on 04' prostock
- Thread starter Guerrilla chief
- Start date
One or two things could be done - Set the Eblade to factory fast (There are ways of making it even faster with the electronic timing but this is the simplest way)
Change the Ram to a one thats made for E cockers ie; Nexus Mag44, Palmers etc etc
Try and reduce your cocking mass - Ie Delrin bolt and back block
should speed things up a little
Change the Ram to a one thats made for E cockers ie; Nexus Mag44, Palmers etc etc
Try and reduce your cocking mass - Ie Delrin bolt and back block
should speed things up a little
I have the eye off when dry firing, and its set on factory fast, but it seems i am pulling the trigger faster than the gun is firing, i am using a carbon fibre bolt that is lighter than delrin.
Any other advice?
I really want to do it with out bouncing.
What are the best upgrades for it?
Any other advice?
I really want to do it with out bouncing.
What are the best upgrades for it?
Im pretty sure you will have to turn up your LPR.
A well setup mech cocker tops out at about 9bps so when you add the Eblade you have a choice. Either you have a slow gun with minimal kick that is gentle on paint, or a fast gun which is hard on paint, kicks alot and tends to bounce.
There are several aftermarket upgrades which will help, you already have a nice light bolt, get QEVs if you dont have them already.
Thats about it, unless you wanna get an MQ valve!
A well setup mech cocker tops out at about 9bps so when you add the Eblade you have a choice. Either you have a slow gun with minimal kick that is gentle on paint, or a fast gun which is hard on paint, kicks alot and tends to bounce.
There are several aftermarket upgrades which will help, you already have a nice light bolt, get QEVs if you dont have them already.
Thats about it, unless you wanna get an MQ valve!
If you have the eyes off then the gun is limited to 12bps isn't it?
so that might just be why you can't get it over 11...
Try it with paint before buying anything.
so that might just be why you can't get it over 11...
Try it with paint before buying anything.
isn't the new board software capped at 12 bps with eyes on or off, try putting it in training mode and seeing what yo get then