Hi just wondering about seting the bolt is the same as on a eblade & mq2 cocker as on a mec cocker thanks
Eblade & mq2 bolt
- Thread starter daniel012
- Start date
If you are referring to the "cocked" position, then no - it's very different.
When you have an MQ(1 or 2) valve the bolt is completely de-coupled, since the sear, hammer & spring are completely removed.
Consequently there is no cocking rod length to set. The bolt will open to the full extent of the ram travel, then close when the eye detects the ball in the breach.
When you have an MQ(1 or 2) valve the bolt is completely de-coupled, since the sear, hammer & spring are completely removed.
Consequently there is no cocking rod length to set. The bolt will open to the full extent of the ram travel, then close when the eye detects the ball in the breach.