eblade eye problem

[mr15bps]

right, eye was working fine in the morning, yesterdat , turned gun off for a while , then turned it on again and the eye aint workin, with same paint as was using earlier, i checked the eye reading, and its sensing a ball in the breach , (aka its changing) whats wrong with it any ideas? could teh ball detent affect this as i did notice that after id shoot a ball wuld roll out the end of the barrel ?

 

[Munkeh]

All cockers will poor barrel to paint match with have balls rolling out of the barrel... Sounds like your eye just needs a clean. Use rubbing alcohol on it. If still no joy buy a new one...

 

[mr15bps]

just found the problem , the detent was getting loose, so the detent was allowing a ball past , hence it went past the eye and the eye was reading an empty breach this also answers the fact that the balls were rollin out, problem sorted just needed a lil bit of loctite on the detent, cheers anyway