e-blade trigger bounce

[Deset]

Hi

according to the e-blade manual, on the filter menu there are two parameters related to trigger bouncing:

TPUL : minimun time in milliseconds to be accepted as a valid trigger pull

TREL : minimun time in milliseconds to be accepted as a valid trigger release

As far as I know the trigger concepts, the smaller value to TPUL the smaller bounce effect and, the bigger TREL value the smaller bounce effect... is this correct?

Anyway using the factory settings fast option these parameters are set (both) to 3 milliseconds so
shouldn't be TREL bigger than TPUL to avoid trigger bouncing?

 

[Noony]

The smaller the values for these parameters, the quicker the gun will cycle!

 

[jahlad]

reducing your 'moving mass' ie the wieght of the cocking mech also helps....change to a delrin bolt and pin....use a lighter cocking rod (titanium) and back block

 

[Silentbob]

But remember

a lighter cocking rod reduces the kinetic enrgy of the hammer, so you may have to put a heavier spring in.

 

[jahlad]

ooops didnt meen a lighter cocking rod, i ment pump rod....my bad

bobs is very correct the hammer and cocking rod are heavy for a reason

 

[Dark Warrior]

tpul=02
trel=40

 

[Deset]

u got my point

Thanks Dark Warrior,

that was what I looking for, since trigger bounce is illegal on competition scene...

 

[Dark Warrior]

If you have shortened the trigger pull just lengthen it very slightly also
Glad to be of help