Dynasty Shocker Breaking Paint...

[Skeet]

Hi peeps...
My mate told me today...that his Dynasty is breaking paint consistently...when up against another shocker, same paint...usng eiether barrel or loader...his gun still chops and the other doesnt...so...they have messed with dwell and ROF...no change...the only differences between teh guns, is my mates has aCP vert reg....he is going to swap over to teh Voodoo one, and see what happens...I have told him to check and clean teh detents...using HALO B Visoion on...any ideas?

 

[Andy]

clean the eye

 

[bruce]

is it chopping the paint in the breech or in the barrel


You may find that the SF oring at the front of the shocker that is ment to seal the bolt just before it releases the gas down the barrel, is causing the problem.

try replacing the o ring with a softer one (same as the ones inside the fire can.

HTH

Bruce

 

[Skeet]

Yeah...just been reading that...17/70 and 17/90...what colour are the softer ones? Also...the "Fire Chamber" is a plastic part like the rest of the bolt assembly is it not?
Where is the best place to get spare o-rings etc..its the High Efficiency SP bolt kit...but do we have to buy from the rip off merchants or can they be got from Evolve tec?

 

[bruce]

they are both white, you can tell once you get it out. the soft oring you can squash between your fingers the harder one you carnt.

speak to the guys at evolve they use the softer ones in there kits

im sure i have some somewhere, pm your address and ill pop a couple in an envelope to you

cheers

bruce

 

[Skeet]

You have PM and thatnk you very much.