Dye proto pmr 09 problems

[Gravilo]

Hi all,
Well just had the bolt out of my pmr 09 cleaned and lubed it all up and refitted it all not a problem. When It can to firing it nothing had it a part again and still no good. Hope someone can help if you can pm your phone number and I'll ring you for help here.

 

[Gravilo]

It like the trigger switch is stuck on but the trigger its self is not touching the switch. Please help.

 

[Gravilo]

Also when I try and put it in program mode it will not cycle through the light colours but if I knock the board the lights will cycle then go round to green and then flash and the lights will turn off until I turn program mode off again then it will cycle through again and go back to normal mode.

 

[Gravilo]

Put a video on you tube to show the problems I'm having with the gun if someone can help. Please

 

[Gravilo]

Well I've found the problem with my gun it's the micro switch and wanted to know if anyone knows which switch to order as a direct replacement .

 

[NitroBall]

Best thing to do is give the guys at Dye a call. If it is just the trigger switch, they should have them in stock.

 

[Gravilo]

Will do fella I did try today but there still closed at the min does anyone know when it's open again

 

[Gravilo]

Just some pics of the board if anyone can help I know the switch looks funny there is no leaver on it as we tuck it out and looked in the switch

 

[NitroBall]

That is not a stock PMR frame and board. That is an UL frame and board you have there.

Not sure where you could get a new switch from, most likely you will need a new board.

 

[darkfirepheonix]

http://www.rapidonline.com/SearchResults.aspx?kw=switch&srb=0&dir=0&icl=1&cat=5499 one if these should be fine dude