dye i4 lens

[alexander001]

hi all,

I click my dye i4 lens into place however it seems to come out a little from the edge of my mask.

It's only a few millimeters but my mates i4 mask doesn't do this and i'd rather be safe than sorry as it look like paint could potentially get in there.

I just want to know if it is safe and if theres anything i could do to stop this from happening.

I can upload pictures on request.

Thanks

 

[alexander001]

the first image is the top of the lens and it seems it is not fully where it should be.

The other picture shows that the bit that should be locking in place is seemingly sliding foward.

 

[smithsmith42]

when you clip it in is there anything stoping it from going a little more in ??

 

[alexander001]

no i put it right in and it clicks however it slowly comes out to the point where i took the picture

 

[alexander001]

it's as if it doesn't lock the lens in place as i can slide it straight out by pulling the strap, i can't seem to get the thing to lock it in place working, i haven't had the mask for too long as i brought it second hand and it has a contour attachment on the side if that might alter the mask in any way?

 

[Newt]

Are the hooks catching the square hole on the lens properly when you pull it back and it clicks in

 

[luke_bond]

Are the hooks catching the square hole on the lens properly when you pull it back and it clicks in

as said here are the clips on the lens and the straps all connected?? its behind the ear protection

 

[alexander001]

This ha been sorted a couple months back, thanks for your interest though