Do i have a hole i shouldnt!? (Geo2 trigger). X

[Teddy picker99]

Here is a picture of my hole

Its the third one down on the actual trigger im talking about. Cant find it in the manual unless im going blind. What does it do? X

 

[red dragon]

Iv just checked on mine for you mate and its the same as yours. As for what its for havent a clue sorry.

 

[automag]

I think it is to do with the trigger centering pin. May be wrong. I dont have a geo 2 at the moment to check but will do next week. (i will remove the trigger and double check for you).

 

[Teddy picker99]

Thanks. i wound it out a bit to see what mite happen, i was hoping it was a short cut to the spring return strength... Almost a full turn seemed to make no difference, so wound it bak in again. X

 

[automag]

If it is the trigger pin centering screw, you may of slightly off centered the trigger.

I would double check the trigger still hits the mirco switch and goes through the optical eyes ok. I will let you know next week for sure