My friend has been having some issues with blocked eye readings on his Virtue board
I have installed the Virtue in my gun yesterday and low and behold,the same issue arised, I was getting the blocked/malfunctioning eye lights.
After stripping the grip down again for the umpteenth time, I realised that it was the eye button on the grip frame not allowing the the eye button on the virtue board enough clearance to function correctly, this then leads to the eye switch being held between the switch actuating points . There must be a very small difference in locations of the stock eye switch than virtue eye switch on the boards.
I have had to remove some material from the back of the eye button to remedy my problem. All it took was about 30-40 passes with a fine toothed file and it now allows the switch to move freely without interference from the switch.
Works with out problems so far.
Hope it helps someone out
I have installed the Virtue in my gun yesterday and low and behold,the same issue arised, I was getting the blocked/malfunctioning eye lights.
After stripping the grip down again for the umpteenth time, I realised that it was the eye button on the grip frame not allowing the the eye button on the virtue board enough clearance to function correctly, this then leads to the eye switch being held between the switch actuating points . There must be a very small difference in locations of the stock eye switch than virtue eye switch on the boards.
I have had to remove some material from the back of the eye button to remedy my problem. All it took was about 30-40 passes with a fine toothed file and it now allows the switch to move freely without interference from the switch.
Works with out problems so far.
Hope it helps someone out
