B
boca
Guest
with my gat i got a little allen key to undo my eyes, but have lost it, does anyone the allen key size im after. i have bought a new set but the smallest one is too big still
B
boca
Guest
ok guys, my head is going west. upto now ive changed battery harness and battery which has got my gun shooting again but im flashing red as if eyes are off and wont turn back on. i stick my finger over the eyes and it turns blue instead of green, from what i can tell the eyes are fine
any suggestions on next move
any suggestions on next move
Sounds like you could do with swapping out your membrane pad for a new one, if you have one.
If you do not have one and want to eliminate the pad, do the following:
Disconnect your membrane pad off the three prongs on your board and then get an allen key and bridge the prongs with it. Top and middle prong together turn the gun on and then middle and bottom prong together turns eyes on and off.........or the other way around, its been awhile since I had my hands on DM5.
If you do not have one and want to eliminate the pad, do the following:
Disconnect your membrane pad off the three prongs on your board and then get an allen key and bridge the prongs with it. Top and middle prong together turn the gun on and then middle and bottom prong together turns eyes on and off.........or the other way around, its been awhile since I had my hands on DM5.
B
boca
Guest
cheers,, thats the point im at either board or membrain pad, will bridge now. if it works then its new membrain pad if not the board has gone
B
boca
Guest
Hi
If you require a replacement DM5 membrane pad then PM me your address and I will send you one.
Regards
Ash Chaplen
Technical Support
DYE Europe
If you require a replacement DM5 membrane pad then PM me your address and I will send you one.
Regards
Ash Chaplen
Technical Support
DYE Europe