DM 12 Leak

[Dygrasi]

New to DMs and this one is leaking from the lpr. I bought it used and it was in a rater bad shape.
I replaced all the o-rings in the lpr, but what i wondering a bout is the set screw, is there more than one and if not in what hole should i place the screw in.
And if there is more than 1 are they the same?

 

[tricky m]

If its the same as older dm's. There are two grub screws under body. One holds the lpr in place. The other is a blanking screw. To block the milling air feed to bolt The front one will want loctited on it. The rear one should be OK without.

 

[Pandamonium]

The LPR has to go back into ybe body in a certain way. Make sure that's the case, then see about turning the LPR in a little and see if the air eventually cuts to the bolt. Also is the marker cycling?

 

[Dygrasi]

ATM i dont know, im out off air. But it helped to know that one hole was to keep the lpr at bay and the other just sealed.

 

[tricky m]

Also if one is longer than the other. The shorter one is the blanking screw.

 

[Dygrasi]

Thanks all.
It was missing the blanking screw.
But got it up and working now, after a lot of small leaks.