confused...air

[dave82]

alright guys, thinkin of changin from an eblade to an angel. i got a 5000 pure energy air but will that be fine on an angel or do i need to change it? thanks

 

[EyeFellOva]

Is it low or high pressure output?

 

[HERMITT]

It depends onwhat angel you are intending on buying and what output prssure you have on your preset. Im guessing that the output pressure is 850psi. If this is the case then you will be fine to run LCD's iR3's and speed 04's. But to run a speed 05 or a G7 then you will need to swap the airsystme for a low pressurescre in.

If you are at Campaign then just drop by the WDP stand and they will be able to advise you on any changes you may need to make.

 

[PaintballBudgie]

03/04 Speeds are also low pressure.

Only ir3s and earlier use higher pressure unless you tinker with the inline reg.

 

[L.i.P.S]

pure energy are normally high pressure 750-850 psi output. If you are going to to buy an angel which requires low pressure you can get a spring kit for a few quid from PMI or your local store or....................us

 

[Spankhammer]

id stick with the e-blade.



Nixon

 

[HERMITT]

Id go with whatever LPS say. They know their shiznit and will do you a decent price on anything you need to change.

 

[Equinox]

i was thinking the same thing...

JustPaintball are selling an Angel 05 with a PMI 500PSI preset, whitch id imagine is 750 to 850...

(whitch i was verry tempted to get..)

i was wondering what would happen if you screw it in as it is..
as i am new to paintball..

Does the Angel have a inline reg capable of reducing from HP?

 

[Tom Allen]

That preset will be 450psi out, low pressure. If it's being sold with the speed 05.

 

[Shades]

Originally posted by Tom Allen
That preset will be 450psi out, low pressure. If it's being sold with the speed 05.

Good Point..

Or make sure that it is fitted with a 450psi out put when purchasing. Running an 05 Speed much higher than 450psi is not very clever.