cocker problems

[stevenrules]

When i have air and paintballs on my e-blade eclipse when i turn the eyes off is shoots fine when i turn the eyes on i can get up to about 3 balls a second can anyone help me.

 

[Lovetone]

Clean the eye, or replace

Ive had the same issue in the past, reverse Eye logic
shoots fine with no paint with eye on.

try this then get back to us if not sorted

to clean eye, unscrew eye cover with hex key, pull eye out and clean with cotton bud, and make sure the eye location hole is cleaned too.

cheers

Ian

 

[Marc0]

Your eyes are either dirty or knackered, so the gun is reducing the cycle rate to prevent chopping.

Check the eyes are clean and the wire from the board is not damaged, you can actually get readings from the eyes up on the led showing their readings to check if they are damaged.

Laters

 

[stevenrules]

thanks will go and clean the eyes

 

[Edd Hobday]

Check all the above but also what paint you using?
If you're usuing black shelled paint the eye won't be able to read it and will cause similar symptons.

-EDD

 

[Lovetone]

not always, but good thing to point out

ive shot black paint fine in my old eblade

 

[stevenrules]

done everything still isnt right

 

[Lovetone]

tested eye with the board?

if that shows error, buy new eye

 

[stevenrules]

done that the eyes seam to be working fine but just isnt right

 

[Lovetone]

try different paint, preferably bright shelled