cocker hp/lp

[Tuga]

what i wanted to know is if cocker(eblade) can run both on hp and lp.
if a cocker can run on a low presure cross fire reg, can it run also on a center flag pre set ?
or is it better to run hp ?
just asking, because im running my dm5 on lp center flag and maybe i could use it in a cocker ! !

thanks for your help ! !

 

[s1im]

allways used a lp on me cockers works a treat. e1 , e1zerob, e2

 

[Lucky]

I believe that the input pressure is 350psi, so a lp reg at 420ish is sufficient. But i have read somewhere that you get a better recharge rate and no drop off if you use a HP reg.
But yes, you should get on fine with an LP set up, but if you do get problems, bear the above in mind

 

[Bob]

the crossfire is supposed to have a great recharge rate so should work fine.

 

[Seejay]

I was told by Some dude at planet (i think it was Nicky T) That cockers are HP. tis what i use mine on and it works like a dream. the inline reg takes the pressure down that's getting put into the gun. Just don't exceed 600psi coming out of the inline reg.

Hope that helps

Chris

 

[Lucky]

Mine works like this
Bottle reg output 850psi
inline reg output 350psi
Lpr output 120psi (ish).
Most people will say that you should use HP regs on a cocker but i know that they can be set up to run at much lower pressures than usual. If you use tuned springs and spend a "LOT" of time setting them up and getting them right the running pressures can be dropped to next to nothing
"but then who's that sad"

"Skeet where are you"?