Cocker CON Time

[Seejay]

Hey guys, i'm looking to get the fastest possible speed out of my cocker, but i am using an agitating hopper, so i cannot have the CON time as low as others, as paintballs will not feed through lack of force fed-ness. My question to you guys is, what is the lowest time that i can set my CON to so it will still load a ball with a gravity feed hopper? i have an E1 frame if that helps.

Thanks, Chris

 

[Skeet]

If your using teh Eyes, as you should be...CON makes no difference as it is set by teh software.

COFF can be reduced...just lower it till you get problems, then up it.

COFF is the time allowed, for the bolt to close and chamber a ball, before the next cycle can start.

Until your loader is as fast as possible, dont worry..or until you have ramping software.

Just use FACT fst...

 

[Seejay]

yeah i use facotry fast now, i just wanna squeeze every last possible bit of speed i can get out of it

 

[Skeet]

Theres no point...what hopper is it?

Get a decent trigger setup on it...qyite long and loose works well...see what rof your getting...lower your COFF time and check it works OK...lower yor CDEL if you dare, but check for blowback through teh feedneck

 

[Seejay]

yeah i got a good trigger setup, trouble is, with the factory fast setting you can only get about 10bps max. i have no air at the moment so i can't do any of the Stuff that requires me to cycles the marker...(damn the lack of compressors in Norwich). i am using an Empire Reloader 2 (the agitating one)

 

[Skeet]

Then your gonna be fine...just do what I said above..wont take long once you have air...find your CON time...which will be at least 30ms, with that loader, I should think.
Then..just increase your COFF time as much as you dare, and then your CDEL a bit...that way...with eyes on...you wont be able to go over 15BPS..

I doubt you will have to increase either by much...