Welcome To P8ntballer.com
The Home Of European Paintball
Sign Up & Join In

changing ion trigger

lemonadeX

Platinum Member
Jul 31, 2006
1,340
2
73
35
(near) Southampton
Firstly you have to take the body off of the whole trigger frame. To do this you need to take out 3 screws using a 1/8" allen key:

1) Right where the trigger is mounted, pointing into the body (this is a bitch to get out btw, because of where its located)
2) A screw right behind the grips if you turn the marker upside-down
3) If you unscrew the barrel, on the sticking-out bit in front of the breach (this is a smaller screw)

Make sure you've taken the battery out (by unscrewing the grips and taking it off the 9V clips). Then carefully pull the body away from the trigger frame, feeding the battery clip out the top with it. This should leave you with 2 main parts to the gun, with the bit to focus on the part with the trigger (of course ;)).

Now you need a tool called a punch (or something similiar, like a small screwdriver). The trigger is held in place by a pin just up and to the right of where its held in place. You need to knock this pin out from the non-gauge side of the marker (the right-hand side if you're holding it pointing away from you). This can be a bit tricky/stiff to knock out.

Once out, the stock trigger can be taken out the top of the trigger frame. Put the new trigger in the same place and punch the pin back into place. Don't worry if the trigger doesn't fit in place fully - post here and I'll give some more tips :)

Hope this helps,

-Will