Can i cut my halo down?

[Lucky]

Are there any problems associated with cutting the feedneck down to reduce the overall hopper height?
Assuming i cut it down in multiples of 0.68 then ball posistion would be the same, but are there any other side effects?
Cheers guys

 

[Martin 123]

Not that i know of, i cut my feed neck down on my realoader b so that the bottom of the hopper sits just on the rim of my feed neck(i cut about 6 or 7 mm off) and it doesnt affect the way the balls are fed into the gun atal, and i played in NSPL with it and it was allowed.

hope this helps

Martin.

 

[lambourne]

Are there any problems associated with cutting the feedneck down to reduce the overall hopper height?
Assuming i cut it down in multiples of 0.68 then ball posistion would be the same, but are there any other side effects?
Cheers guys

I had no problem cutting down my new halo so it fits better on to my etek.

i chopped of around 8mm use a new hacksaw blade, and if you can get some one to hold it helps

 

[Tom37]

ive had no problems, but then ive mainly shot reballs through the gun, and only a bit of paint

 

[SWAT-Jay-]

there is no problem, i did it with my halo b and reloader...all is good

 

[Dskize]

Are there any problems associated with cutting the feedneck down to reduce the overall hopper height?
Assuming i cut it down in multiples of 0.68 then ball posistion would be the same, but are there any other side effects?
Cheers guys

apparently there can be serious problems with halo's due to screwing up the ball positioning and the eyes having problems .but it appears you already know that

i would heartily recommend switching to a re-loader board if your going to do this bud

 

[SpAnKy1000]

apparently there can be serious problems with halo's due to screwing up the ball positioning and the eyes having problems .but it appears you already know that

i would heartily recommend switching to a re-loader board if your going to do this bud

Hit it spot on buddy!

Spank's N.K #69

 

[Paul_Mardon]

Make sure once you cut it to sand all the frilly bits of the end , i was getting Pi**ed off when i kept choping paint to sh*t , then found it it was where i cut my halo down and it still had ruff edges at the bottom.
Just worth checking this out i sanded it all down nice and smooth never had a problem since.

Paul.
Pretty In Pink (PiP)

 

[Skeet]

Can I cut down my Halo?

Don't hassle yourself mate, just leave it till the Euro 5 Man, pop it out of a bunker and I will cut it down for you mate

 

[Lucky]

Don't hassle yourself mate, just leave it till the Euro 5 Man, pop it out of a bunker and I will cut it down for you mate

pure class Gaz, pure class
"you do know that you need to enter to try and carry that out, don't you? "