Hello dudes
my bolt is seroiusly sticking on my impulse its well lubed and the o rings look fine
any ideas
Joe99
my bolt is seroiusly sticking on my impulse its well lubed and the o rings look fine
any ideas
Joe99
By bolt keeps sticking on my impy
- Thread starter joe99
- Start date
dry fire?
Is it doing bolt stick during dry fire, when using paint, or both?
If thats the case, probably a tapeworm is the answer!
Is it doing bolt stick during dry fire, when using paint, or both?
If thats the case, probably a tapeworm is the answer!
Speaking of dry firing, it's a really bad idea to dry fire an Impy anyway. It will cause recocking problems. I think a tapeworm eliminates that problem, but don't quote me on that.
you would be better off getting a voodoo bolt - with no o-rings. if it still sticks then the FFv or tape worm are the next add on but a voodoo bolt should do the job
o.k...........
There are many reasons why your impy bolt could be sticking forward,
1. The ball detent. it could be holding the bolt by the o-ring.
2. problems with pressure.
Yes a tape worm will help this but it might be that your pressure is to high. This makes the bolt stick forward. Try ajusting the dwell.
What pressure do you have going into the gun?
Do you use co2 or air?
Hope this helps,
Chunk.
There are many reasons why your impy bolt could be sticking forward,
1. The ball detent. it could be holding the bolt by the o-ring.
2. problems with pressure.
Yes a tape worm will help this but it might be that your pressure is to high. This makes the bolt stick forward. Try ajusting the dwell.
What pressure do you have going into the gun?
Do you use co2 or air?
Hope this helps,
Chunk.
And to support the master himself I have dryfired my Impy a lot - and without any modifications beside my Bladetrigger I have never had any problems with boltstick (except when I shoot over 1.000 balls a match without having the bolt lubricated berfore...)
Pinky
