Brand new PMR noid gasket Blown

[fodder]

Hey, I just bought a PMR and after going to gas it up found it to be pissing air out above the trigger somewhere.

After removing the frame and the noid I found that the gasket that sits above the noid was wrecked. Annoyingly this seems to be the only spare seal that didn't come with the gun.

Anyway I've been told to contact a bloke called Ash at dye about it by my local site and was wondering if anyone on here has his contact details. Thanks.

 

[Stan]

Ash's user details on here: http://www.p8ntballer-forums.com/vb/member.php?u=12129
Or your best bet - give him a ring at Dye: +44 (0) 208 649 6330 ext. 207

 

[Ghostrocket]

Just for your info i maybe wrong but as Ash plays with Nexus i think they are in San Diego at the mo

 

[fodder]

Thanks mate just rang up & they were really helpful. Got everything sorted now.

 

[fodder]

& i jst spoke to ash there so they must be back

 

[Stan]

Thanks mate just rang up & they were really helpful. Got everything sorted now.

Glad to hear it.

 

[Ghostrocket]

Ah ok thanks

 

[fodder]

Right, my new gasket arrived & I've put that on along with changing the bolt O-rings and theres still a leak, anyone got any suggestions what I could try next?

Thanks.

 

[Ash - GI Sportz]

Check that you haven't over-tightened the screws when re-fitting the solenoid. They should be screwed up 'finger tight' then give it an extra quarter turn.

Also, check your reg pressure is not set too high or too low. The reg should be set to somewhere between 2 and 3 turns. (To set the reg, wind it all the way in until it stops, then turn the adjuster anti-clockwise 2-3 turns, adjust to chrono accurately)

Ash Chaplen
DYE Europe