Bits that don't work!!!!

[s1im]

I've decided to start a marker project that I have been putting off for years,
similar to a cocker in principle but not a cocker if you know what i mean!
To see if all the bits will fit i'm after some bits that do not need to work!!
As its very early days I just need these to take measurements from for cad etc
Ideally as cheep as possible (donations even if you want future opportunities!)

remember all of these bits do not have to work at all!!!!!!
mq2
e2 board
dye u/l back
break beam eyes that would normally work with an e2 (although they don't have to work!)
any dye u/l frame and grip. (broken scratched etc)
2x large delrin bolts or 1 large 1 ego etc

 

[Tom Allen]

Ambitious, but i doubt you'll get a variety of manufacturers parts to align into a working gun, even if you make the body yourself.
Markers are designed around the air chambers, and of course the size of the ball.

Allthough, if it's never intended to work then i'm sure it'll look great.

 

[s1im]

hi tom,
Most bits will be butchered quite significantly!!
It will (fingers crossed) work in the end as all the bits needed are proven in other fields (most bits going into it are not paintball related!)and will theoretically work ! these bits are needed to check sizes etc, and yes the body will be made by me!

 

[Tom Allen]

if you're going to make the body, you may as well go the "whole hog" and make it completely.

There are many improvements to be made to the current designs.

 

[Tom Allen]

I have a tap for the cocker barrel thread if you're stuck. Depending on your design it may be easier by tap than directly machined.