Bit Of Advice Please?

[HERMITT]

Alright guys!

Just got my grubby mitts on a real nice Vision Impy 2k2 and I need to know what the input pressure into the front mounted maxflow reg should be? Its coming out of an aramgeddon if that helps!

Cheers peeps

 

[Parksy]

So you have a vert Maxflo on the impy? If so I have the same setup on my Eclipse Impy, and the Armageddon I have is set to 450psi. Think the general rule is about three times the pressure in the vert maxy, there is another thread on this somewhere cause I asked the exact same question, and everyone said about 450-500

Hope that helps

Dave

 

[HERMITT]

Cheers mate!

 

[Noony]

Hermitt,

For the love of god, please just leave it be, it will all end in tears! LOL

See ya sat!!

 

[Flash-Bugout]

Noony, I see it hasn't taken Hermitt long to establish a good rep with kit in his new home!

Hermitt - pls, pls, pls, pls, pls, pls, just hand it to someone who has better "luck" with kit than you, and ask "make work nice please"

 

[Jamie]

anything over around 450psi will be fine i wouldnt go much lower then that or you may experience shoot down when firing fast.

 

[Flash-Bugout]

Hermitt, when Jamie says anything over 450, whatever you dont take that literally, and put 2000 thru to your 2ndary reg

 

[ABBA]

In the manual it says 650-750 psi but that is for a stock one. If its that stripy armaggedon then i reckon about 3000 should do it, just to be safe

 

[Jamie]

Originally posted by Flash-Bugout
Hermitt, when Jamie says anything over 450, whatever you dont take that literally, and put 2000 thru to your 2ndary reg

Thanx for adding that bit