Best input pressure for Matrix

[Davo]

Ok, guys, got an LCD matrix with new Evolve bolt kit and need to know the best input pressure,

I have a preset reg which I assume if its like most others will have an output pressure of around 800psi.

Will this be OK, as it would seem that the top hat on the bolt has been damaged which I've been told could be due to too high pressure going into the gun.


Also, sweet spotting the reg via the LPR, I was under the impression that this is how I do it.

1.Set the LPR at about half way
2. Adjust inline reg until required velocity if found, adjust LPR outwards until velocity drops off, then screw LPR in 1/2 turn and lock it off

Do I need to do anything else to get the marker running sweeter?

Thanks

 

[L J]

it shouldnt matter what is going in as your inline reg will lower it, my inline reg is set at 200

 

[L J]

to set my lpr i set it just above where it stops firing. then chronied my marker with the inline, and then turned the lpr until i noticed the fps going down, turned it back up slightly and left it. then was shocked to find that when i fired it, there was no kick at all