Take of your air system (bottle)
Take off barrel.
Clean barrel in hot soapy water...give it a poke with fluffy stick, set aside to dry.
Remove bolt.
Wipe whole gun down with damp cloth to get rid of dried paint and grime etc.
Run squeegee or fluffy stick through the gun where bolt goes.
Clean the eye.
Apply touch of lube (light oil) to bolt and rub over it, not loads, put bolt back in.
Pull back on back block.
Apply oil to ram shaft and work shaft back and forth to lubricate the o rings in the ram.
Done.
Do NOT, oil the internals...the hammer etc can run dry, otherwise it picks up grit and crap and will ferk your gun up.
As advised by Flash at Eclipse some time ago.
The only other thing, is, depending on use...lubricate your sear with a high temperature grease, Wurths something or other, Planet used to sell it...but that is like, twice a year...I never done it as I didn't feel it was required given the use they got.
I use WDP Love Juice, as a light oil.
