Anyone have access to a CnC?

[Demonic69]

Need to get some milling done for my Shockers BB eyes. Looks like it will be tough just with a mill so may need a CnC. Just wondering if anyone has access/time to look at this
All it will need is one side mirroring onto the other. Hole for eye and eye-wires I reckon.
The angle for the internal hole can be got by sticking an allen key down the current hole and reversing the angle I think.
Thanks to the guys who got me this far

Cheers

 

[John C]

Maybe Im stating the obvious but have you tried Sir Thomas of Allen?

He has a digital mill... its a beast.

 

[mikey601]

Maybe Im stating the obvious but have you tried Sir Thomas of Allen?

He has a digital mill... its a beast.

a bit like tom

 

[Mr. Suicide]

I'll second that notion

Luke.

 

[Demonic69]

I have indeed. I think he was worried about the clearances between the solenoid inserts and the breach.
Didn't get a reply from my last PM so guessing he's not keen on attempting it

 

[mikey601]

He's just a bum....


Going down in a bit will ask him for you again mate

 

[Tom Allen]

I have indeed. I think he was worried about the clearances between the solenoid inserts and the breach.
Didn't get a reply from my last PM so guessing he's not keen on attempting it

I thought i had replied, i said send it down and i'll draw up the layout on autocad to see what clearances i have.

 

[Demonic69]

Maybe it was during a mass-deletion moment. It's like the final scene with the bad guy in Tron when I start clearing out my PMs
Drop me the addy mate and I shall post forthwith

 

[Tom Allen]

I'll need it stripped as much as you can.

 

[Demonic69]

Okie Dokie. Might have to leave some small air-passage screws in the bottom, that OK? Shouldn't affect anything.

Cheers