Sawing a halo feedneck down to fit a clamping feedneck better?
Just done it to both my halo shells and dropped the overall height by about 7mm
Just done it to both my halo shells and dropped the overall height by about 7mm
Anyone else tried???
- Thread starter Graham-DV8
- Start date
cool, gald to here, shouldnt have any negative effect on speed since its a force fed loader, if anything speed it up by a very very very small amount
Did both me Halo and Reloader, plus my lil' bro did his a few months back - awesome, esp. on CCM pro feednecks.
When you cut down an eyed halo you do lose peformance slightly as the system is designed to have the face of the ball up against the sensor at rest (as opposed to the gap between 2 balls being up against the sensor at rest).
It doesnt make a great deal of difference, but it does make a difference...
It doesnt make a great deal of difference, but it does make a difference...
It was on my empire reloader, so no problems with the eye to worry about
But cheer's for the thumbs up about the mod
But cheer's for the thumbs up about the mod