Angel LCD 2002 trigger bounce

[Mazz]

Gotta big prob!!

Don't have a clue whats caused it but I have a trigger bounce prob and I've gotta get it sorted before the D7's. there isn't a spring in the trigger bit so that could be a problem, however when it was in there it bounced more!!!

Would a stronger spring be a good method of fixing it?

Any help guys?!?!

Cheers

 

[Stan]

Not a tech but in theory i would say yes, a stronger spring would help. Also make the pre and post travel a little longer.

 

[John C]

It is probably as Stan says that you need to lengthen the trigger and put a harder spring in.



It may also be due to excessive wear on the microswitch (if your trigger is quite long already but pulling the trigger results in more than one shot). If this is the case then you probably need a new board

 

[Stan]

Or get a friendly electrician to remove the old switch and solder on a new one