angel IR3 trigger and solenoid

[bigpete]

is there meant to be a ' click ' noise from the solenoid every time the trigger is pulled ? because when i pull the trigger on mine the click doesnt go with the timing of the trigger , im kind of worried because ive already had problems with it a few weeks ago and i havent actually used it yet

 

[MattyMorgan69]

yes the click is quite normal, its not a very sharp "crack" but definatly a noise. How far out of time is it? it's probably fine unless its noticably half a second+ out.

cheers.

 

[Tom Allen]

Yes there is supposed to be a click from the solenoid. If it is about a second'ish after the trigger pull, then the solenoid connector is connected to the intellifeed socket by mistake.
Pull the grip cover off and have a look, it's simple to swap it over.

 

[KitsuneAndy]

Also, if your triggers not set up properly then not every trigger pull will register. you may be pulling the trigger before it's came far enough forward to reset itself

 

[bigpete]

yea most of the time when i pull the trigger it doesnt register and then on the odd occasions it clicks but clicks really slowly

 

[John C]

It really does sound like you have the solenoid wire plugged into the intelifeed port as Tom says.

 

[bigpete]

ye ive just swaped them over and its working fine now , thanks for all your help