Angel HP mod

[Sharpie]

Can the ones the that you left use High Pressure Air, and do they have the mango internals?

 

[Sid Sidgwick]

Can the ones the that you left use High Pressure Air, and do they have the mango internals?

Just a quick heads up, the regs can take HP all you need to do is change the orientation of the shims in the reg and your done.

 

[Lump]

Can the ones the that you left use High Pressure Air, and do they have the mango internals?

Just a quick heads up, the regs can take HP all you need to do is change the orientation of the shims in the reg and your done.

I have just moved these two post here. Can some one link to the how to do this for him ??

 

[Sid Sidgwick]

Here you go...

http://www.angelowners.com/showthread.php?78193-mini-reg-HP-shim-stack

 

[Hawkins]

be sure not to damage the oring on the hpr as you remove the stack...

 

[Mutey]

What would you do after the shims have been changed? Do you only need to adjust the Velocity screw and the LPR so the gun can achieve the correct fps or is there more to it? The manual says the mini reg should be at 350ish psi and the LPR at 65 psi, would that mean you'd have to get the pressure back to those after the reg mod?

 

[Sid Sidgwick]

pressure should be fine after the mod, you can check your pressures using the gauges once the mod is complete.

 

[Lump]

Thanks Sid

 

[Sharpie]

Cheers for this Sid

 

[Mutey]

So it is just do the mod, adjust the velocity to match and all is good to go?