My a1 tends to leak by where the hose fits into the handle. I was going to replace it but just wanted to know how to properly take the hose off and put it back in before i break it lol
angel hose
- Thread starter 12inchbarrels
- Start date
mate by the hose do you mean the macro line? and secondly by handle do you mean the reg?
and if you want to get it out there will be a ring on the macro line connector, push that ring in and pull the macro line out.
or just wait for TOMALLEN to reply to this thread he'll know what to do.
and if you want to get it out there will be a ring on the macro line connector, push that ring in and pull the macro line out.
or just wait for TOMALLEN to reply to this thread he'll know what to do.
Most of the time quite a few leaks are caused by badly cut macroline, dosent sound like a major prob.
true, but if itsnt a big leak leave it there isnt any need to fiddle about with it.
unless you want too.
unless you want too.
As Motocrossboy has said, press the collet/shoulder of the fitting in and pull the macroline out, you may need to twist it a bit to get it out.
The important thing with macroline is :
1. cut it square
2. make sure the macroline goes into the fitting straight, any deviation from straight will cause a leak.
3. I you need to bend the macroline heat it in the steam of a boiling kettle, and bend to just a bit more than the required radius then quench under cold water to keep the shape.
The important thing with macroline is :
1. cut it square
2. make sure the macroline goes into the fitting straight, any deviation from straight will cause a leak.
3. I you need to bend the macroline heat it in the steam of a boiling kettle, and bend to just a bit more than the required radius then quench under cold water to keep the shape.
KK cheers guys