Angel Air remote

[zorglet]

HI guys,please bear with me as I am very new to the sport,
I just got an X7 and I have an Angel air with the LCD reg. However the LCD reg's "out" opening needs something to screw into it. I am assuming it's ASA.
I would like to run it remotely, the Coil is fine to screw into the gun itself, but I am unsure as to what I need to screw into the angel Air reg to allow me to attach the remote hose to the bottle.

Any advice would be much appreciated.

Many Thanks
z

 

[Tom Allen]

what is on the end of the remote lead

 

[zorglet]

http://www.pbupz.net/images/remotemain.jpg

Hi there, this is more or less what I was looking at, with the quick release and connector screwing into the gun with the other end supposedly screwing into the bottle (which of course I can't do since the stupid Angel Air has a female connection and I cant seem to find a male to male connector)

Just to confuse things a little something that I have seen that looks like it might work... is the CO2 pin valve (that gives you an idea of what i need, a male connector screwing into the bottle which then in turn supplies male connector for the remote hose to screw into.

Thanks for taking the time out to help me

 

[Tom Allen]

remove the female end of the lead and replace it with an 1/8 bsp elbow, screw this into the angel air and connect the asa adaptor to the asa on the gun

 

[zorglet]

Thanks for the reply Tom, just to get it straight, the black ASA ( the piece that would normally screw onto the top of the bottle) I need to take that off and connect that to a 1/8 bsp elbow?

I bought this
http://www.hustlepaintball.com/product-p/32170301.htm
as I thought this was what I needed

I will look at finding a 1/8 bsp elbow, just need to confirm if I want to unscrew the right end of the remote hose !
Thanks for the help so far!!

 

[Tom Allen]

Yes, the end with the "Z" logo on top is the one to remove. Then you'll need a male to female 1/8 bsp elbow to connect the remaining male 1/8 bsp fitting that's on the lead to the angel air system.

I have an elbow here you can have, just pm me your address and i'll get it off to you tomorrow.

 

[Tom Allen]

if you're unsure about this you can send it to me and i'll set it up for you.

 

[zorglet]

Really sorry about the loads of posts... but the website seemed to have died for me last night. Thanks for deleting.
I would greatly appreciate if you could give me a hand. I don't mind buying the elbow from you, to be pedantic, I like fiddling with these things myself ( since I might have to fix it at some stage myself )

So I remove the bit with the z logo, , screw the elbow into the angel air and connect the bit left on the remote hose to the elbow?

Sorry to sound stupid, but just want to get it right in my head !

Thanks again!