Angel AIR Reg

[Lo Scannacristiani]

Is it possible to screw one of these electric angel AIR regs into a 3000psi bottle rather than a 4500?
Cheers

 

[Dskize]

yes

btw i posted the eggy stuff today sorry i forgot -doh

 

[Lo Scannacristiani]

No worries mate. Would i need to change out the burst disc?

 

[Dskize]

if theres a 4500 burst disk on it then yeh you should change it but i thought the only burst disk was on the output (the hex bolt with the metal plate) - maybe id better pass this on to Mr C or Mr Allen its been a couple of years since i owned an angel A.I.R

 

[Stan]

As ^ he says, ask Tom Allen.

Both my AIR regs have 7500 stamped on the burst discs on what looks like the input side.

The pressure release on the output side is the small red thingy that goes pppppfffffffffffffrrrrrrrrrttttttttt if it gets dirt in the reg, etc

 

[Lo Scannacristiani]

I have two burts on my preset one say 1800 and the other 5K so assume i will need to change the burst disc on the AIR.

 

[crumpler]

a 5k burst disc is for a 3000psi bottle and a 7.5 burst disc is for a 4500psi bottle. So if you reg already has a 5k one in it then its much only be a 3000psi reg ot someone else has already changer it to 3000psi.

The 1.8k one is for the out put half of the reg so it dont creep up and put 3000/3400psi into your gun and kill it

 

[Lo Scannacristiani]

Sorry mate i was talking about a PMI preset that i have with 2 burts on it. The ARI only has the one with 7500 stamped on it. Looks like it needs to be changed

 

[Paul_Mardon]

or you could just not fill ur bottle over 3000psi? that way you wouldnt need to change any burst disks would you :S?

 

[Tom Allen]

The angel air does have a 4500 psi burst disc installed(7500 marked) For safety reasons you should change this to a lower one, but very few do.