guys put a halo on the alias and it was double feeding does anyone know where i can get some harder ones.
alias ball detents
- Thread starter ashley
- Start date
Double feeding - you sure?
I've never had a Timmy that physically double fed, and my Alias with a ReloaderB performed just peachy for the 5 cases I put through it recently.
If they are gettign breaks, try the bolt placement it's probably too far back, if so get an adjustable ram cap (Hybrid do the only one for an Alias out at the moment).
Otherwise if you really think you need new detents www.paintballkingdom.com have them.
I've never had a Timmy that physically double fed, and my Alias with a ReloaderB performed just peachy for the 5 cases I put through it recently.
If they are gettign breaks, try the bolt placement it's probably too far back, if so get an adjustable ram cap (Hybrid do the only one for an Alias out at the moment).
Otherwise if you really think you need new detents www.paintballkingdom.com have them.
thats the only thing i could think of because when i use an egg its fine but then when i used a halo it smashed paint
you can try tightening the detents, sometimes on some guns the factory doesnt tighten them all the way
if you had breaks with a Halo and not with an egg then I'm 99% certain that it's the bolt placement, nothing to do with the detents.
look down the feed tube when gun is gassed up, you should be able to see the first 1 or 2 mm of bolt "nose" sticking out into the chamber.
on an alias you can add a shim, or another oring behind the white oring on the ram cap to have the bolt sit further forward.
look down the feed tube when gun is gassed up, you should be able to see the first 1 or 2 mm of bolt "nose" sticking out into the chamber.
on an alias you can add a shim, or another oring behind the white oring on the ram cap to have the bolt sit further forward.
If in doubt, gas the thing up and put the HALO on, then take the barrel off and look into the chamer. If there's a ball from the feedneck partially in the breach, and the ball in the breach has rolled back into the face of the bolt, you need to move the bolt.
