hey guys i have a new trigger come and i think i need strip my ion down whats best advice on doing it bear it in mind i have to re use all the trigger componants. Cheers
advice on stripping down a ion
- Thread starter Nortwest_Paintballer
- Start date
Take off the trigger frame, I don't think you need to remove the grip, but it gives you a clear view of the board and trigger alignment afterwards.
Pop out the trigger pin (It only goes one way, so if tight its probably going in the wrong direction)
Swap triggers, replace the pin
Test the trigger and adjust as required
Pop out the trigger pin (It only goes one way, so if tight its probably going in the wrong direction)
Swap triggers, replace the pin
Test the trigger and adjust as required
heres a really really good tip,,,,DOWN LOAD THE ION OWNERS HAND BOOK ITS FREE,,,you could even print it out,,,and keep it in your kit bag,,,
then you wont have to send it to me when you cock it up,,, or..have a look at my you tube films,, theres shed loads of stuff on there to do with the ion,,, shed loads,,,, just type gommie404 in to you tube,,
then you wont have to send it to me when you cock it up,,, or..have a look at my you tube films,, theres shed loads of stuff on there to do with the ion,,, shed loads,,,, just type gommie404 in to you tube,,