4 way problem
- Thread starter fatbeerboy
- Start date
you got a hinge or slide trigger?
(cheque posted earlier by the way couldnt get a stamp last nite)
(cheque posted earlier by the way couldnt get a stamp last nite)
On a hinge trigger, they go round the opposite way...I think the middle one goes to the LPR...so just try it and see, if it works backwards then you know which ones to swap!!
On mine the hoses go:
back hole (nearest block): back of ram (nearest the block)
middle: lpr
front (furthest): front of ram (furthest from the block).
Hope that helps.
back hole (nearest block): back of ram (nearest the block)
middle: lpr
front (furthest): front of ram (furthest from the block).
Hope that helps.
Sounds about right to me...Kudos on the explaining as well, like that, getting the fronts and backs right!
I have limited experience with 3 ways and such, having not owned a mech cocker, but I thought that was what it would be, having looked at some...
I have limited experience with 3 ways and such, having not owned a mech cocker, but I thought that was what it would be, having looked at some...
LPR hose always goes to the center hole. On a hinge frame, the hose from the back of the ram goes to the back of the three way, and the hose from the front of the ram goes to the front of the three way. On a slider frame, the two ram hoses are reversed from the configuration I just described (front of ram to back of three way, back of ram to front of three way). One of the imutable laws of autocockers, everybody who owns one should know that.