why wont

[unleash the freak]

hey guys just started playing and Ive just got a pm7 brand new, but for some reason i cant get it to work. iv put a new battery in, the air system is full. when i start it up the red light comes on and turns green when a paintball is in the feed but when i pull the trigger nothing happens and the light blinks green. what am i doing wrong

 

[Potter Loki]

is the trigger activating the microswitch? is the noid clicking when you pull the trigger? aired the gun up?

 

[Lump]

is the air on ? is the front reg would in enough for air to get to the marker,

start with the basics

 

[unleash the freak]

as far as i can tell, it is ive adjusted the front reg and went through all the dwell settings like it said in the manual. thanks lump but any other ideas?

 

[Rich ECI]

Have you screwed in the knob on the asa?

 

[e-whore]

Does it have a training mode? i spent 20 mins fixing an ego that was in training mode LOL

 

[unleash the freak]

Have you screwed in the knob on the asa?

in just new to the sport not dumb lol just kidding ya mate

 

[unleash the freak]

its not in training or configuration mode im afraid. dont have a clue whats wrong, must just be me hehe

 

[Jesus]

ok then,

the eyes blinking green means theres an eye fault, but this sounds like its being caused by you pulling the trigger and there being no movement in the breech which means the soleniod is activating when you pull the trigger.

this leads me to beleive its deffinately an air issue, but to double check, disconnect the air and hopper and then turn the marker on. Now turn your eyes off by pressing the bottom button under the power button. the light should start flashing red. now when you pull the trigger you should hear the solenoid clicking?

lmk

 

[unleash the freak]

thanks jesus tried that and still aint working. ive used the air system on my mates marker and let rip a few balls in the garden, the air systems working fine