paint to barrell match

[scooby_doo]

Hi folks, just got an evil pipe kit. How are you meant to work out which back to use with your pballs.

I have 3 different pballs on the middle pipe back two balls go straight through the third one goes in but then lodges until pushed through.

anyone know of any online resource for this?

Scoob

 

[J@mes]

you basically want three points of contact, and you should be able to see light around the ball, other than the three points of contact.

-james

 

[Big Mac]

i just got a freak kit - and i figured that there is the one that it fits into and requires the most air to push it out - go for the size above that, if its too big - then it decreases the accuarcy - i think! but go for the size up above

 

[Demon]

you basically want three points of contact, and you should be able to see light around the ball, other than the three points of contact.

-james

basically take this advice!

 

[Tom Allen]

get half a dozen balls and drop them one by one into the backs until it takes a soft blow to get one through. Try all 6 as they may vary in size, but don't get it too tight.

 

[mikey601]

you basically want three points of contact, and you should be able to see light around the ball, other than the three points of contact.

-james

I've never been that technically minded, hence me always having 200 markers to hand, but why 3 points of contact?

 

[Big Mac]

its to do with the accuracy i believe. james will no doubt expand fully. i read it somewhere but forgot it

 

[Tom Allen]

how was the weekend mate, everything go ok.

 

[mikey601]

how was the weekend mate, everything go ok.

Weekend was top fella, drinking pints of champagne had to be one highlite of the event, there were others but none i can go into here

 

[Tom Allen]

i'm sure the pics will tell a few stories.