Air Pressure Gauge

[olliewidd]

Im looking for an air pressure gauge that runs between 0 - 500/600 psi. Its for a cocker reg tester so i need to be able to adjust the regs between 350 and 450 psi and the 500/600 gauges have the best dial increments to do that

Also after a cheap as chips ASA to mount the dial onto

Thanks

 

[BOD]

http://www.flowfitonline.com/hydraulic-pressure-gauges/flowfit-pressure-gauges/63mm-glycerine-filled-hydraulic-pressure-gauge-0600-psi-41-bar-14-bsp-rear-entry?gclid=CJGj68Ct7sYCFefItAodp6gESQ

though you would need to get a thread adapter 1/8 bsp thread as well, also i would suggest an on/off purge ASA is better for making a pressure tester out of because you can turn it on and off quickly to test recharge rates.

 

[Banil]

http://www.flowfitonline.com/hydraulic-pressure-gauges/flowfit-pressure-gauges/63mm-glycerine-filled-hydraulic-pressure-gauge-0600-psi-41-bar-14-bsp-rear-entry?gclid=CJGj68Ct7sYCFefItAodp6gESQ

though you would need to get a thread adapter 1/8 bsp thread as well, also i would suggest an on/off purge ASA is better for making a pressure tester out of because you can turn it on and off quickly to test recharge rates.

Sorry to the OP for the threadjack. But I though you required NPT threads for regs/ASA plugs. Are BSP and NPT the same? Or different?

 

[olliewidd]

http://www.flowfitonline.com/hydraulic-pressure-gauges/flowfit-pressure-gauges/63mm-glycerine-filled-hydraulic-pressure-gauge-0600-psi-41-bar-14-bsp-rear-entry?gclid=CJGj68Ct7sYCFefItAodp6gESQ

though you would need to get a thread adapter 1/8 bsp thread as well, also i would suggest an on/off purge ASA is better for making a pressure tester out of because you can turn it on and off quickly to test recharge rates.

Will that gauge not mount directly onto an ASA then? What size are macro fittings in comparison to this as 1/8 bsp mwans absolutely nothing to me

 

[uberjuba]

anil is right, you require 1/8npt, bsp is a different thread and should not be used.

 

[BOD]

correct, i meant to say 1/8npt .

 

[BOD]

Will that gauge not mount directly onto an ASA then? What size are macro fittings in comparison to this as 1/8 bsp mwans absolutely nothing to me

no it won't, that's why i said you would need a thread adapter. if you google 600psi pressure gauges you may find what you're looking for easier than finding some one who's got one for sale.

 

[BOD]

Thread adaptor, http://www.nero.co.uk/catalogue/product.aspx?node_id=9429eb8c-9cc9-47ed-9830-3faefda07800

 

[BOD]

or one of these if it's a female fitting on the back of the gauge. https://www.merlinmotorsport.co.uk/p/adaptor-1-4npt-x-1-8bsp-male-male-adp-1-4npt?utm_source=Google&utm_medium=ShoppingUK&utm_campaign=ShoppingUK&vat=on&currency=GBP&gclid=CI2FztDR7sYCFXDHtAodXI0JSQ

 

[Bullseye]

Not sure if this is any good?