Ego 11 issue

[olliewidd]

Hi,

My ego 11 is having serious velocity issues to the point where the reg is fully open and yet the marker wont shoot any higher than 250 fps.

I discovered this a while ago and since have had the marker stripped and given a full o ring rebuild, reset the LPR and HPR, reset the solenoid and a fresh procell in

Im now completely out of ideas and kind of at my wits end. Was told today it could be that the solenoid is knackered but I havnt got a clue

Any ideas/advice would be great

 

[StewartW]

first thing. ditch the procell and try it with a decent high end battery. Its not a sales gimmick the battery can have drastic affects on markers.

 

[frenchy2475]

I have used procells for years, they are made by duracell. I have known the odd duff but very rare. Try another battery, just to be on the safe side.

 

[olliewidd]

first thing. ditch the procell and try it with a decent high end battery. Its not a sales gimmick the battery can have drastic affects on markers.

Tried 3 different batteries yesterday, all with the same result.

 

[StewartW]

Tried 3 different batteries yesterday, all with the same result.

All Procells?

What's your solenoid SFRs set too?

 

[olliewidd]

All Procells?

What's your solenoid SFRs set too?

1 Duracell and 2 procells, all brand spanking new. The SFR is on 5 and 7

 

[Nicky T]

What is your dwell setting at?

Does anything change if you raise the SFR's to 10 and 10?

Nicky T

 

[olliewidd]

What is your dwell setting at?

Does anything change if you raise the SFR's to 10 and 10?

Nicky T

The dwell is set to the factory setting. I didnt want to mess about the SFR as I wasnt sure if Id blow the solenoid.

 

[Nicky T]

You won't blow it

First thing to do is to reset your Inline Regulator as per teh manual to it's factory setting, once you have done that then please try these two things:
- Set the SFRs to 10, 10 and test.
- Reset the SFRs to 5,7 and raise the dwell by 1.0ms and test.

Nicky T

 

[olliewidd]

You won't blow it

First thing to do is to reset your Inline Regulator as per teh manual to it's factory setting, once you have done that then please try these two things:
- Set the SFRs to 10, 10 and test.
- Reset the SFRs to 5,7 and raise the dwell by 1.0ms and test.

Nicky T

What shoud I do should these two things not work??